Pansat 2700A/E Manual Code entry....

Autoroll must be turned off!!
To turn off do this....

Get the codes...
Menu, Parental Control, OK, 2nd Pin, 0000
Scroll down to autoroll option and hit OK.
Select dishnet, left or right arrow to turn of, then select Bev and do the same.
Exit, Nagravision2, OK
Right arrow (provider ID should now read 09 01
Key number should say 00.. if not make it.
Position your cursor with on the first byte and start entering in the 1st half of key 00.
Move to the second line and enter the last half of the key.
verify and then press OK, and the ok/store symbol on the bottom right of your screen should blink a few times.
Move back up to the key number and change it to 01.
Position your cursor with on the first byte and start entering in the 1st half of key 01.
Move to the second line and enter the last half of the key.
Verify and then press OK, and the ok/store symbol on the bottom right of your screen should blink a few times.
Exit,exit,exit,exit and you should be fine now.  if not? check your work
 
Note... Look at the codes allready in place before you start entering as usually you will only need to put in either key 00 or key 01. 

CODE ENTRY.. numbers are simple but you will need to insert letters from A-F as well... your remote can do this for you.  For "A" press the pause key, B= audio key, C=epg key, D=last key, E=fav key, F= satkey